What is a scalable –48 V DC Pol solution?

This article presents a scalable and stackable –48 V DC PoL solution that will address the high density power usage situations created by these high density networks from the tremendous growth in network traffic. Telecom and wireless network systems typically operate on –48 V DC power.

Why do telecom networks use –48 V DC power?

Telecom and wireless networks typically operate on –48 V DC power, but why? The short story is that –48 V DC, also known as a positive-ground system, was selected because it provides enough power to support a telecom signal but is safer for the human body while doing telecom activities.

What is a -48V back-up battery converter?

The -48V back-up battery converter is similar in construction and complexity to the single-output, high-power VoIP converter previously discussed. The power factor corrected (PFC) AC/DC produces the supply voltage for the 3G Base station's RF Power amplifier (typ. +27V) and the bus voltage for point-of-load converters.

Can a –48 volt DC power a PA?

However, the –48 V DC must first be efficiently converted to a positive intermediate bus voltage before it can be boosted to power the PA or stepped down to a positive workable supply for the digital baseband units (BBU). A power supply with a capacity of 100 W to 350 W was sufficient to cover many applications.

What is a -48V to multiple output converter?

In a DSL application, a -48V to multiple output converter may be used which incorporates a more complex, lower power transformer (50-100W) with several outputs.

What voltage does a DSL power system supply?

The DSL power system may supply both higher voltage analog line drivers and amplifiers (typ. +/-12V) and several low voltage supplies required by the digital ASIC (+5V, +3.3V, +1.8V, +1.5V).